MASCO Catalog: Construction Liquid and Powder

Read manufacturers' data sheets for complete specifications, installation procedures, and MSDS precautions. Warning : Chronic health effect possible—inhalation of silica dust may cause lung injury/disease (Silicosis). Take appropriate measures to avoid breathing dust. See page 179-180 for more information. 51 MASONS SUPPLY COMPANY Oregon (800) 537-3407 ♦ Washington (800) 537-6216 ♦ www.MASCO.net Clackamas | Eugene | West Eugene | Hillsboro | Medford | Portland | Salem | Ridgefield | Seattle | Tacoma | Woodinville Everclear VOX Final Coat Description : EverClear VOX is a water-based, pure acrylic sealer for concrete with excellent blush resistance and total resistance to yellowing from UV exposure. This sealer imparts an attractive sheen and protection to all concrete surfaces, and is especially suited for decorative concrete. EVERCLEAR VOX is formulated to be compliant with all VOC regulations in the United States and Canada, and its low odor makes it usable indoors or out. EVERCLEAR VOX dries to a clear, medium-gloss finish, but a higher gloss can be achieved with additional coats. • Non-yellowing, medium-gloss sealer provides protection and improved appearance to concrete • Low odor • Excellent abrasion and blush resistance • Can be applied over previous coats of sealers – water based and solvent based • Excellent recoatability • Can contribute to LEED points Applications: • Concrete driveways, sidewalks, floors • Stamped, stenciled, colored, acid stained concrete • Concrete pavers and precast units • Cultured stone • Terrazzo Application Standards: ASTM C309, Type 1, Classes A & B AASHTO Specification M 148, Type 1, Classes A & B Coverage: Curing & Sealing Fresh Concrete 1st Coat: 300 to 400 ft²/gal 2nd Coat: (optional) 300 to 400 ft²/gal Sealing or Re-sealing Existing/Cured Concrete 1st Coat: 300 to 400 ft²/gal 2nd Coat: 300 to 400 ft²/gal Specifications : Drying Time: < 1 hour Recoat: 4 to 24 hours Foot Traffic: 4 to 6 hours Wheel Traffic: 6 to 10 hours VOC Content: 93 g/L Solids Content (by weight) > 25% Description : A high solids acrylic polymer floor polish for gloss and durability. This unique formulation provides maximum scuff and heel mark resistant gloss for lower maintenance costs. Final Coat requires fewer coats than are needed with conventional lower solids products and stays glossy even after numerous scrubs. Provides stunning "wet-look" highlights to colored or stamped concrete floors. Application : Recommended for use in malls, hotels, retail stores, hospitals, and schools. Final Coat can also be used on most conventional resilient floors (rubber, asphalt tile, vinyl, linoleum, and all types of composition tile). Use on: • Troweled, colored or stamped concrete • Conventional resilient floors • Concrete paver tiles • Vitrified brick • Glazed tile • Terrazzo Limitations : Not for unsealed porous surfaces. Not recommended for exterior use. Surface can be slippery when wet. Coverage : 500 – 1500 sq.ft ./gal. For exact coverage rates, a measured quantity to proper cleaning over a known area will provide a square foot coverage rate for a specific job. Specifications : At 75˚ F Tack Free: 1 hr Recoat Time: 1 hr Light Traffic: 1 hr Vehicle Traffic: 2 hrs Final Cure: 12 hrs No. Size EU 5GECVOX 5 gal pail, 36/pallet No. Size GST 1GFC 1 gal. pail, 4/case, 45 lbs. ACRYLIC EMULSION Sealing / Hardening Compounds