MASCO Catalog: Concrete Forming & Accessories

75 MASONS SUPPLY COMPANY Oregon (800) 537-3407 ♦ Washington (800) 537-6216 Clackamas | Eugene | West Eugene | Hillsboro | Medford | Portland | Salem | Ridgefield | Seattle | Tacoma | Woodinville M A S C O . N E T TIEING/HANDSET SWL provides a factor of safety of approximately 2 to 1. COIL THREAD Nut Washer Coil nut washers are available with 3/4" acme or coil thread diameters. Made of ductile iron, the nut washer is designed to take the place of a loose hex nut and flat washer. No. Size SWL Tension (lbs) Wt (lbs) DS 31348 3/4" Acme 9,000 1.30 DS 31346 3/4" Coil 9,000 1.30 Other sizes available on request. Speed Bolt & Nut Special fitting up bolts and nuts are used for securing steel form panels together. The tapered nose of the bolt acts as a draft pin and helps align the forms. The thread design and clearances between the nut and bolt permits quick assembly and dismantling of the forms. The open thread design permits concrete to be easily knocked out of the threads. LOAD REDUCTION FACTORS Contact our technical service department for load reduction factors for angles other than those shown. WARNING! When angle loads are placed on the weld angle bracket the SWL must be reduced as shown. If the SWL is not reduced, greater loads than expected will be applied thereby reducing the factor of safety. Actual SWL depends on the strength of the field weld, coil rod used, and angle betweeen the coil rod and the weld plate. No. Size Wt (lbs) SY 32191 3/4" x 2" 0.50 SY 32195 3/4" x 3" 0.60 SY 32194 3/4" x 4" 0.70 SY 32193 3/4" NUT 0.30 S L r vi s f t r f s f t f r xi t l 2 t 1. .70 x SWL .86 x SWL .96 x SWL 1.0 x SWL .96 x SWL .86 x SWL .70 x SWL 45 O 30 O 15 O 0 O 45 O 30 O 15 O No. COIL THREAD DIAMETER MAXIMUM SAFE WORKING LOAD TENSION (LBS) CFA WAB12 1/2" 9,000 CFA WAB34 3/4" 18,000 CFA WAB1 1" 31,500 Angle Tie Bracket This bracket offers a full 110 degree movement 55 degrees in either direction. Designed to eliminate the unsafe practice of field bending of coil rod or bolts. Masons assumes no liability for the welded connection.