MASCO Catalog: Concrete Forming & Accessories

200 MASONS SUPPLY COMPANY Oregon (800) 537-3407 ♦ Washington (800) 537-6216 Clackamas | Eugene | West Eugene | Hillsboro | Medford | Portland | Salem | Ridgefield | Seattle | Tacoma | Woodinville M A S C O . N E T TILT-UP/PRECAST TILT-UP Drill-In Lift Plate For use in Tilt-up panels when lifting inserts cannot be located. Consult Masons for technical information. Note: Drill in lift plates develop approximately 5 to 1 factor of safety. See special instructions for more information. Form Angle The Form Angle (shelf bracket) is used for tilt-up perimeter forming is fabricated from 18 gauge galvanized steel which allows for numerous re-uses. The two sizes of holes permit various attachment methods. Used to fasten the angle to the floor slab and form lumber. Suggested spacing is 2'-0" on center when using 2x lumber as edge forms. 50 pcs per carton. No. Description SWL Wt (lbs) DS 10052 6 bolt (3 per side) 15,000 lbs SB ELP 8 bolt (4 per side) 22,000 lbs 35.0 No. Size Wt (lbs) CT CF6 7/8" x 5-3/16" x 6-15/16" 1.0 Slab Saver II A patented product manufactured from durable polypropylene, molded into a "T" section with stem. The purpose of Slab Saver is to eliminate the scarring and damage of the concrete at time of lifting a tilt-up panel. After edge forms are put in place, a 2' piece of Slab Saver is put into each bottom corner of the panel and nailed into place. Concrete is poured, vibrated and consolidated around the stem of the Slab Saver. Nails are pulled and forms are removed. Slab savers are made from durable PVC and will not scratch your floors. They are easy to install and will help reduce your installation costs. Concrete nail Slab saver Concrete Form No. Size Qty/Ctn Wt/Ctn (lbs) PS 734 24" 42 38.0