MASCO Catalog: Concrete Forming & Accessories

195 MASONS SUPPLY COMPANY Oregon (800) 537-3407 ♦ Washington (800) 537-6216 Clackamas | Eugene | West Eugene | Hillsboro | Medford | Portland | Salem | Ridgefield | Seattle | Tacoma | Woodinville M A S C O . N E T TILT-UP/PRECAST TILT-UP Gyro Tilt Plus System Insert - The GTP inserts are simply wired to the rebar mat at designated points. No special orientation is required but reasonable care should be taken to assure that the insert is the correct overall height for the panel and remains perpendicular to the panel face during concrete placement. Hardware - After proper concrete cure, the GTP Hardware is attached to the crane rigging and moved to the panel to be picked. The plastic void cap is removed from the insert assembly and the void checked for foreign matter. The hardware is then placed in the void in the "open position" which allows the hardware to nest into the ring of the "closed position" engages the hardware ball/detent lock-up, captures the insert and allows the lifting sequence to begin. Visual inspection will confirm proper hardware installation. SWL provides a factor of safety of approximately 2 to 1 in normal weight 2,500 psi concrete. Consult manufacturers data on values on shear and reduced edge distance. GYRO TILT PLUS INSERT FACE LIFT SAFE WORKING LOADS Panel Structural Thickness mm 5" 5½" 6" 6¼" 6½" 7" 7¼" 7½" 8" Insert Safe Working Load 8,000 10,000 12,000 12,000 13,000 15,000 15,000 15,000 15,000 Gryo Tilt Plus Hardware in open position Hardware nested in the insert void Installation Complete Locking Ball in position Ground release chain NOTE: This surface painted red. In the open (unlocked) position the red paint will provide a quick visual warning that the hardware is not in a locked (lifting) position. Rotate ring to engage hardware to insert and to position locking ball Locking Ball Insert