|
GROUT FLUIDIFIER/PUMPING AIDS |
|
|
 INTRUSION AID "R"
SLICK PAK
SLICK PAK, II
|
VIEW TECHNICAL DATA SHEET
Intrusion Aid "R"
|
|
Description: A fluidifer for grouts and concrete that promotes flowability, reduces water requirements, reduces bleeding and segregation, increases strength and eliminates setting shrinkage.
| No. |
Size |
| MB INTRUS |
2⅔ lb. bag, 24/case, 65 lbs.
|
RETURN TO TOP
|
Application: The excellent fluidity and flowability make it ideal for pumping grout into block walls, under slabs and foundations, filling cracks and crevices in dams and piers, shoring up deteriorated beams and columns, and pumping augured cast-in-place piles. |
Applicable Standards:
ASTM C-937 & CRD C-619.
Dosage: 1 lb. approximately is recommended for each 100 lbs. of cementitous material to provide proper expansion and fluidifying characteristics. Should be added in powdered form to the grout mix at the job site.
|
|
VIEW TECHNICAL DATA SHEET
Slick Pak
|
|
Description: A dry powdered pump primer and pumping aid packaged in a patented, ready-to-use, water soluble bag. Slick-Pak is uniquely formulated for the concrete pumper.
| No. |
Size |
| Slick Pak: |
| FZ 97134 |
8 oz. bag, 60/case, 32 lbs. |
RETURN TO TOP
|
Application: Is a lubricant agent for pipe and hose. In addition, Slick-Pak is compatible with all conventional concrete materials and can be used as any standard concrete pumping aid. |
Dosage: Use the following directions to prime one hundred feet of five inch pump line: Add an 8 oz. Slick-Pak bag to a five-gallon bucket of water.
Note: When the concrete contains superplasticizers, we recommend doubling the amount of water used to prepare the Slick-Pak solution for pump priming. |
|
VIEW TECHNICAL DATA SHEET
Slick Pak II
|
|
Description: A dry powder concrete pumping aid packaged in a patented, ready to use, water soluble bag. Slick-Pak II is uniquely formulated to provide the concrete pumper with a cost effective method for improving the pumpability of hard to pump and/or harsh concrete and grout mixes. Additionally, it reduces line pressure, improves flow properties and increases the rate and range of pumpability. In addition, Slick-Pack II contains no bentonite, cementitious materials, soaps, or air entraining agents.
| No. |
Size |
| Slick Pak II: |
| FZ 97136 |
8 oz. bag, 60/case, 32 lbs. |
RETURN TO TOP
|
Application: Improves pumpability of hard to pump mixes. It also decreases hose pressure.
As a Concrete Pump Primer:
Use one water soluble inner bag in 5 gallons of water to prime 100 ft of 5-inch pump line. Double the water if the concrete contains superplasticizers.
|
Dosage: Approximately 1.5 to 2.5 ounces per cubic yard of concrete or grout. Typically, one 8 oz. bag will treat 4-5 cubic yards. |
[BACK TO 3050 ADMIXTURES FOR CONCRETE & MORTAR]
RETURN TO TABLE OF CONTENTS
|
Liquid + Powder 
